To start the test session for a batch job, type the load module name as the input transaction code. Because it is an online test, we recommend that you use a small volume of data during testing.
Note: The Test Facility does not support DL/I access by external action blocks.
For batch procedures, the Batch Manager uses three special files. These files are allocated with data set names prefix.IEF.TIRxxxF. The value for prefix is specified during host installation.
After executing the test, examine the TIRMSGF and TIRERRF files to view the results. The TIRIOVF file is cleared when a procedure completes successfully.
When a procedure completes successfully, an end of job message displays on the screen. If the procedure fails, CA Gen runtime error messages are written to the screen only as when an online procedure step fails. Clear the screen before initiating another test.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|