After you enable the Diagram Trace Utility, invoke your application as you would normally.
When an application is being tested, any of its procedure steps and/or action blocks that have been generated with trace will communicate with the Diagram Trace Utility. No additional information is displayed with the application screens; the application will wait until control is returned from the Diagram Trace Utility.
The Diagram Trace Utility lets you step through the execution of the application by viewing the sequence of action block calls and action diagram statements being executed as the generated program executes.
Note: For more information about the Diagram Trace Utility, see the Diagram Trace Utility User Guide.
|
Copyright © 2013 CA.
All rights reserved.
|
|