Configuring a Comm. Bridge as a Windows System Service › Removing Using the GUI Interface

Removing Using the GUI Interface

Following are the steps to remove service registration using the Comm. Bridge GUI interface:

Follow these steps:

1. Start the Comm. Bridge using one of the following methods:

   From an Icon, open the CA Gen folder and double-click the Comm. Bridge icon.

   From a command prompt, change to the directory where you installed the Comm. Bridge and type the following command:

   IEFCBxxN.exe iefcb startup /initfile=[filename]
   

   Note: xx refers to the current release of CA Gen. For the current release number, see the Release Notes.

   IEFCBxxN.exe

   Specifies the name of the Comm. Bridge executable

   iefcb

   Specifies the transaction code associated with the initial procedure step. This is a required parameter.

   startup

   Specifies the initial command executed by the initial procedure step. This is a required parameter.

   /initfile=

   Is followed by the name of the initialization file to be used for this Comm. Bridge instance. If possible, use the filename used when the service was previously registered. If that file in not available, the name of the service to be deleted can be entered into the file manually.

   Prior to starting the Comm. Bridge, ensure the target service has been stopped using the Windows Control panel Services utility.

2. From the Comm. Bridge main window Select File, Setup menu items
3. On the File – Setup dialog click Service Config. . This brings up the Service Configuration Details dialog.
4. Within this dialog ensure the required Service Name field is correct if populated, or else enter the Service Name to be removed. The remaining items are not used for the remove service operation.
5. Click Remove Service to remove the service information from the Windows Operating system services repository.
6. A status dialog will report the success or failures of the service remove operation.