Introduction › Guided Tour › Starting the Version Control Client

Starting the Version Control Client

Follow these steps:

1. Start the CA Gen Version Control Client either by clicking on the Version Control Client icon or by entering the following command line command:

   	iefvc vcfunc open	
   

2. Enter the CSE Servers host name, service name or port, your CA Gen user ID, and the password if your account requires one, and click OK.

   Note: The hostname field can contain a hostname, a hostname with domain name , or an Internet Packet version 4 (IPv4) or version 6 (IPv6) address. The hostname can be a maximum of 1024 characters in order to accomodate host and domain names that contain non-ASCII characters.

3. If you are authorized for more than one encyclopedia, select the required encyclopedia, then select Logon.

   For more information, see one of the following procedures:

   • Performing Object Comparison (Chapter 2)
   • Performing Adoption or Trial Adoption (Chapter 4)
   • Performing Migration or Trial Migration (Chapter 5)