The CLEAN command submits a clean request for one or more ICM and/or RMT files, either locally or remotely. If there are multiple files to process, the processing occurs sequentially. After you submit the CLEAN command, control is returned to the interactive mode. You can submit additional CLEAN commands for the local machine or for any of the remote machines that have active Build Tool Servers running on them. To retrieve status information on a submitted CLEAN command, use the STATUS command. You may exit the interactive mode after a CLEAN command is submitted, and may re-enter interactive mode later to check on the status of the clean.
The CLEAN command removes all produced files that are based on the outcome of the previous BUILD command. This includes, but is not limited to:
Only the files that are split from the .RMT (if you are dealing with an .RMT file) or the files that are originally generated locally (if you are dealing with an ICM file) remain. When a CLEAN command is completed, the remaining files are left so that a full build can occur the next time when the BUILD command is issued against the same ICM or RMT file.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|