Editing Data Sets › Edit Commands › Primary Commands › MAP › Specify Record Offset Value Using MAP Command

Specify Record Offset Value Using MAP Command

You can specify a record offset value at the layout level in CRL using the MAP command.

Follow these steps:

1. Type MAP on the command line from an edit or browse session.

   The Custom Record Layout Member Update screen opens.

2. Type the line action S on any layout member.
3. Press Enter.

   The Layout Entry Field Update screen opens.

4. Specify a new record offset value in the Record Offset Value field.
5. Press Enter.

   A new value is set for this updated layout member only.

Note: Specify a 0 (zero) in the record offset field or leave the field blank to reset the record offset value.