C1EI messages are issued by CA Endevor SCM. When describing corrective actions, the messages use the following codes:
A indicates that action should be tried again, after increasing the region size. If this does not work, proceed according to the other suggestions for corrective action.
B indicates that the full message text and return codes should be provided.
C indicates that either a SYSM or SYSABEND dump should be provided.
D indicates that the concatenation for the PIDT table should be provided.
E indicates that data set attributes should be provided.
F indicates the JES job log and all output listings should be provided.
G indicates that the script used as input should be sent to the batch utility.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|