You can run the Autogen option in simulation mode in batch to see what the results would be without actually performing actions with Autogen activated. Simulation mode causes the actual execution of all actions in the batch job to be bypassed. No updates are performed. The C1MSGS1 and C1MSGS2 reports will show the Syntax Request report and Action Summary report as if the actions were executed. There will be a heading line, labeled "*** AUTOGEN SIMULATION ***" to indicate that the job ran in simulation mode. Use the reports for impact analysis to see what the results would be if the actions were performed.
To activate simulation mode, append the EN$AUSIM DD statement to your batch job or use the include JCL option to add the DD statement. An example of the DD statement is shown next:
//EN$AUSIM DD SYSOUT=*+
|
Copyright © 2014 CA.
All rights reserved.
|
|