Troubleshooting

This section contains the following topics:

Source Management Fails on Edit Session End

Generate Processor Fails on Edit Session End

Source Management Fails on Edit Session End

Symptom:

When I entered the End command in an ISPF Edit session, I got an error message indicating that a source management failure occurred as CA Endevor Quick Edit was writing the element to CA Endevor SCM, but the Edit session remained open. How do I make sure that any changes I made in the Edit session are saved?

Solution:

Do the following:

Use the Edit CREATE command to save the element in an external data set.
Enter the Cancel command to terminate the Edit session.
After you correct the problem, you can edit the element again. Use the Edit session Copy command to replace the element displayed with the element saved in Step 1. For more information, see Copy from an External Data Set.

Generate Processor Fails on Edit Session End

Symptom:

When I issued the End command in an ISPF Edit session, CA Endevor Quick Edit displayed a message data set. The message indicates the Generate Processor was not invoked. When I finished reading the message, CA Endevor Quick Edit redisplays either the CA Endevor Quick-Edit Option panel or the Element Selection List depending on which panel I used to invoke the Edit command. The ISPF Edit services were not reinvoked.

Solution:

Do the following:

Use the EDIT option to verify that the element is correct. If necessary, you can use the GENERATE ELEMENT option to regenerate the current level of the element.