This section describes what you need to do to start CA Endevor SCM.
This section contains the following topics:
How to Configure for Existing Clients
How to Configure for New Clients
How to Complete Configuration With CA CSM
How to Complete Configuration Without CA CSM
After you have installed the product files using CA CSM or ESD to an SMP/E CSI, additional tasks are required. These tasks prepare the SMP/E target files and your installation environment to enable you to configure CA Endevor SCM as appropriate for your organization. The necessary tasks are referred to as deployment and configuration tasks. How you perform these tasks depends on whether you are using CA CSM. How you perform these tasks also depends on whether you have an existing installation of CA Endevor SCM or you are installing CA Endevor SCM for the first time.
Note: During deployment, you copy the installed SMP/E target libraries to deployment libraries. When you configure deployment libraries, you create what are referred to as runtime libraries.
After the product files are installed, you can create a deployment using CA CSM. To create a deployment, click the Create Deployment tab in the SMP/E Environment for the installed instance of CA Endevor SCM. Then, follow the instructions in CA CSM.
To create a deployment without using CA CSM, create copies of the SMP/E target libraries using standard IBM utilities. These copies are your deployment libraries. Use these libraries for your configuration.
|
Copyright © 2014 CA.
All rights reserved.
|
|