Set the options and parameters you require in the Export to External Format wizard to convert data in an CA ERwin Data Modeler model to a format supported by another application.
Note: The export process will not complete unless you have saved the model before you start the export process.
Select a destination type to which you want to export from the drop down list. This list is populated with the currently available bridges.
This is the location to which the exported file will be saved. The same file name is used, however if a file by this name already exists, then the export appends a number to the file name. For example, if you already have a file name of test.dsx, the export creates test1.dsx, and so on. You must have a location specified in the Location field, or you will not be able to complete the export process. Click the button to open the Save As dialog to change the location of where the model will be exported and saved.
Edit the parameter values for the selected destination type within the grid as needed. You click on a parameter and then enter a value in the Value column. Required parameters have a red flag. If you do not enter a value for a required parameter, the page is invalid and the Finish button is disabled.
Note: The tip text area located at the bottom of Source and Destination pages displays helpful information about the active (selected) field. Wherever appropriate, complete the requirements before proceeding.
Copyright © 2013 CA.
All rights reserved.
|
|