On this panel you are prompted to enter the name of an already-existing data set in which the names of processed data sets can be saved. The record length of this data set must be at least 50 and it must have a sequential organization.
The purpose of this facility is to allow the user to automatically generate utility commands, either for CA Disk or some other program, for the data set names that appear in the report. Although this panel does not actually generate the commands, you must specify the data set name here in order to produce the commands later on. It is always a good idea to save the data set names that appear on the report if there is even a remote chance that you will want to generate utility commands for them. After this panel has been bypassed, it is impossible to respecify this value until the next online report request.
For more information, see the section CMDGENDSN= in the chapter "Reports."
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|