DASD Billing › Accumulate JCL for VSAM Clusters

Accumulate JCL for VSAM Clusters

The following section describes the JCL and control statements needed to run the BILLING functions against VSAM clusters. It is equivalent to the SCAN and ACCUMULATION process used for non-VSAM data sets. This is the only portion of the billing function that is unique to VSAM cluster billing.

Keep in mind that the EXTEND procedure will process both the VSAM and non-VSAM records.

//jobname JOB (acct,info),etc.
//DAILY    EXEC VSAMBILL
//DMS.SYSIN DD  *                              <— NOTE use of STEP NAME
* Specify the following DSCL commands for VSAM billing.               *
PASSWORD MASTER=,CATALOG=                                  (optional)
SCAN CATALOGS=/                                            (required)

EXCLUDE CRITERIA=(DSORG,NE,VSAM)                       (required)
SELECT CRITERIA=,DSN=,VOL=,TABLE=                      (optional)
EXCLUDE CRITERIA=,DSN=,VOL=,TABLE=                     (optional)

BILLING                                             (required)

//ACCUM.SYSIN   DD  *                         <—  NOTE use of STEP NAME
* ACCUMULATE COMMAND as described for non-VSAM                        *

A sample job to accumulate VSAM billing records is as follows:

//jobname JOB (acct,info),etc.
//DAILY      EXEC VSAMBILL
//DMS.SYSIN   DD  *
SCAN CATALOGS=/

EXCLUDE CRITERIA=(DSORG,NE,VSAM)

BILLING

//ACCUM.SYSIN DD *

ACCUMULATE BMONTH,MODE=IMMEDIATE,BYPASSNEW