Previous Topic: Accumulate JCL for Non-VSAM Data SetsNext Topic: ACCUMULATE Command

DASD Billing › Accumulate JCL for Non-VSAM Data Sets › SELECT Command

SELECT Command

The SELECT command is used to scan DASD volumes and retrieve the DSCB for each data set on the volume.

The SELECT command syntax is:

SELECT VOLUME=,DSNAME=
VOLUME=

A list of one or more volumes or volume prefixes to which scanning is to be confined. (A maximum of 100 entries is supported.)

DSNAME=

A list of one or more data set names and patterns to which the processing is to be limited. (A maximum of 25 entries is supported.)