Password-indicated data sets can be selected for migration by using the PASSWORD parameter on the MODESET command. Since conventional tape support does not allow both indicated and non-indicated data sets to be placed on the same tape, this parameter causes ONLY indicated data sets to be scanned for possible selection. If selected and migrated, the original password will be needed to access the tape data set.
If it is desired to process non-indicated data sets as well, a separate job execution is made but without the PASSWORD parameter. This technique results in two different series of tapes being created, one with only indicated data sets and the other with only non-indicated data sets.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|