The DELETE command instructs CA Disk to delete the non-VSAM data sets and VSAM clusters that satisfy the selection criteria. No backup copy of the data set is taken.
Note: Use this command with care. If used improperly, unrecoverable DATA LOSS can occur.
Always run this command in SIMULATE mode first. Running in SIMULATE mode determines exactly which data sets will be deleted. Keep in mind that because CA Disk does not make a backup copy of the data set during delete, you cannot recover the data. By default, CA Disk does not allow this command. To use this command, specify sysparm DELETEOK with a value of Y.
Even with DELETEOKy, this function does not delete an ICF or VSAM catalog. Also you cannot delete data sets beginning with SYS1 unless you set sysparm SCRASYS1 with a value of Y.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|