Reason:
RELOAD processing abnormally terminates because a sequence error was detected in the designated logical file. The first 51 bytes of the out-of-sequence record and the one preceding it are displayed. Sort the unloaded sequential data set, and then attempt the reload again.
Action:
Sort the unloaded sequential data set, and then attempt the reload.
if you receive this message as a record of the sub file RETEXCLD, after running the DBREVERS procedure, change the RETEXCLD key length from 50 to 44. Make this change in the FILEDEFN PARMLIB member. Run DBREVERS again. See the RETEXCLD sysparm for more information.
Note: If this message is generated for a record of the sub file RETEXCLD as a result of running the DBREVERS procedure, change the RETEXCLD key length from 50 to 44 in the FILEDEFN member of the PARMLIB and then run DBREVERS. For more information, see the RETEXCLD sysparm.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|