Installing Your Product from Pax-Enhanced ESD › Receiving the SMP/E Package › Prepare the SMP/E Environment for Pax Installation

Prepare the SMP/E Environment for Pax Installation

The members in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Disk. External DDDEF data sets are required. The default is NULLFILE.

For information about the members, see the comments in the JCL.

To prepare the SMP/E environment for your product

1. Customize the macro SDMSEDIT with your site-specific information and then copy the macro to your syslib location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type SDMSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your yourHLQ.SAMPJCL members.

   Note: Set the DASD HLQ to the same value specified for yourHLQ for the unzip to DASD ESD JCL.

   Note: The following steps include instructions to execute the SDMSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the SDMEDALL member.

2. Open the SAMPJCL member SDM1ALL in an edit session and execute the SDMSEDIT macro from the command line.

   SDM1ALL is customized.

3. Submit SDM1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Disk are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member SDM2CSI in an edit session and execute the SDMSEDIT macro from the command line.

   SDM2CSI is customized.

5. Submit SDM2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.