To Disable or Enable the JES2 Exit6 Interface

If the JES2 Exit is implemented, circumstances later can occur where you need to disable or enable the JES2 Exit.

You can disable the JES2 Exit6 processing in the following ways:

Disable the exit within JES2 itself
```
$T EXIT6,DISABLE
```
Nullify (no‑op) its processing
Rename PARMLIB member ARJES2XT and restart CA Vantage GMI.

If this member with your exclusion filters is not found, all processing within the exit is bypassed. (System parameter ARJESMBR provides the name of the member with your filters. It defaults to member ARJES2XT. If you use a different member, simply rename it, or change sysparm ARJESMBR to specify a non-existing member.)

To enable the exit again, reverse the process you used above:

Enable the exit within JES2 itself
```
$T EXIT6,ENABLE  
```
Activate exit processing
Rename the member back to ARJES2XT and restart CA Vantage GMI.

When the member is found, all processing within the exit will start.