Reference › DSA Commands (DXserver Commands) › Commands Reference › set auth-trap Command—Set the DSA to Raise an SNMP Trap When Authentication Fails

Previous Topic: set attribute Command—Define an Attribute

Next Topic: set busy-for-referral Command—Send Busy in Place of LDAP Referrals

set auth-trap Command—Set the DSA to Raise an SNMP Trap When Authentication Fails

The set auth-trap command is a mechanism that can be used to hook into the authentication processing on the DSA using SNMP traps. When set to true, this command turns on raising an authentication trap whenever an authentication failure occurs.

This command has the following format: 

set auth-trap = true | false;