Administration Guide › Set Up the Sample Directories › Create Democorp DSAs on the New Hosts

Create Democorp DSAs on the New Hosts

When you used the Single-DSA wizard to create the Democorp backbone, you configured a Democorp DSA on one host. You then created two more hosts, without creating a DSA on them. The following instructions describe how to create Democorp DSAs on the two new hosts.

To create Democorp DSAs on the new hosts

1. Navigate to the Topology map.

   Right-click a host, select Instantiate a new partition to this host, and then select As a Data DSA.

2. The Instantiate Namespace Partition as a Data DSA page opens.
3. Select the Democorp option in the Namespace Partition list.

   The details should be correct.

4. Click Next, and then review the list of network addresses for this host. If the list is correct, click Finish.
5. Repeat these steps for the third host.
6. Save this version of the configuration, as follows:
   1. Click Configuration, Save.
   2. Enter a comment that describes the current state of the configuration, and then click OK.

   You can now create UNSPSC DSAs on the new hosts.