Reference Guide › DSA Commands (DXserver Commands) › Commands Reference › set multi-write-error-trap Command

set multi-write-error-trap Command

The set multi-write-error-trap command determines whether an SNMP trap is sent when a replicated update is refused.

The trap will contain diagnostic information on why the update failed.

The SNMP trap is only sent if traps are configured.

When multi-write-error-trap is set to true, then the following rules apply:

• If a DSA cannot update a peer DSA because the peer is unreachable then the update request is queued and sent later: no trap is sent.
• If a DSA can send a request to the peer DSA (the peer is reachable), but the peer refuses the update, then the sending DSA sends a trap, because a refusal to accept a request shows some data inconsistency, which could be a serious issue.

This command has the following format:

set multi-write-error-trap = true | false;