Reference › DSA Commands (DXserver Commands) › Commands Categorized by Function › Commands for Multiwrite Replication

Commands for Multiwrite Replication

Use the following commands to enable and configure multiwrite replication:

• clear multi-write-queue Command—Remove Entries from Multi-Write Queue
• get dsp Command—Display the DSP Configuration Values
• set dsa Command—Define the Knowledge Settings of a DSA
• set multi-write-disp-recovery Command - Enable Multiwrite-DISP Recovery
• set multi-write-dsp-idle-time Command (obsolete but still supported)
• set multi-write-error-trap Command
• set multi-write-group-credit Command
• set multi-write-outstanding-ops Command
• set multi-write-queue Command
• set multi-write-retry-time Command
• set wait-for-multiwrite Command