The VSE Console has a specific toolbar, which is comprised of the following buttons. You can also access these functions by pointing at a service and right-clicking.
The VSE Console toolbar contains the following commands:
Deploy/Redeploy |
|
Deploys or redeploys a virtual service to the environment. |
Start |
|
Starts a virtual service that you selected. |
Show |
|
Displays the inspection view for the selected virtual service. |
View |
|
Displays session/tracking information for the selected virtual service. |
Set |
|
Specifies how the selected virtual service should behave. |
Reset |
|
Resets the transaction and error counts for the selected virtual service. |
Stop |
|
Stops the selected virtual service. |
Remove |
|
Removes the selected virtual service from the environment. |
Configure |
|
Configures tracking data cleanup. |
Shut down |
|
Shuts down the entire virtual service environment. |
Groups |
|
Selects whether to display services associated with all groups, with no groups, or with one group. |
Deploy a new virtual service to the environment
To deploy a virtual service from a model archive (MAR), select this option.
Enter the name of a model archive (MAR) to upload. The MAR must contain a virtual service. When you click Deploy/Redeploy, the service loads into the VSE Console and the service is available to run.
Start the selected virtual service
Starts a virtual service that you have selected.
A confirmation window opens to indicate that the service has started. Click OK.
Show the inspection view for the selected virtual service
The Show Inspection View button opens a tab for an inspector panel that is tailored for virtual services. This panel has two tabs, Matching and Request Event Details.
Copyright © 2014 CA Technologies.
All rights reserved.
|
|