Previous Topic: Create a Subprocess Test CaseNext Topic: Subprocess Example

Using CA Application Test › Using the Workstation and Console with CA Application Test › Building Test Cases › Building Subprocesses › Convert an Existing Test Case into a Subprocess

Convert an Existing Test Case into a Subprocess

Follow these steps:

  1. Open the test case and rename it appropriately.
  2. Mark the test case as a subprocess in the Test Case Information tab of the test case.
  3. Remove any data sets that provide the values of properties that are to be input properties of the new subprocess.

    The exception is when a data set is integral to the subprocess logic.

  4. Remove any properties from configuration files, or a companion that initializes parameters that are to be input properties of the new subprocess.
  5. After the input and output properties are checked and all the input parameters have default values, you can run the subprocess in the ITR.