Reference › Test Case Reference › Filter Descriptions › VSE Filters › Data Protocol Filter

Data Protocol Filter

The Data Protocol filter is used on protocol-specific listen steps for virtual models. It provides the necessary wrapper for a data protocol to act as a filter, which is the appropriate functionallity for the VSE run-time side.

To open its editor, click the filter.

Complete the following fields:

Filter in

Enter the response to which to apply the filter. The previous graphic shows lisa.Get User.rsp, which means that the filter is applied to the response of Get User. You cannot change this value for this filter.

Data Protocol

Select the appropriate data protocol to be used from the drop-down list.

Process Requests

Select to see the process request.

Process Responses

Select to see the process response.

Run Filter

To run and execute the filter, click Run Filter. The results appear in the Filter Run Results section.