DevTest auto extracts several internal properties of messages into properties in the test step using the Extract Payload and Properties from Messages filter. You can also select to auto extract the payload into a property. This method is a fast way to get data from a message.
Different messaging platforms impose various restrictions and can be seen as warnings at run time.
The property names can default to lisa.stepName.message, or you can specify the prefix. You can specify an exact name for the payload.
Complete the following fields:
The name of the property to consider as the last response for the step. If the property is not in the pull-down menu, you can enter it. The property must exist.
Select this option if you require a payload.
Enter or select the property key to use as the payload.
Enter the prefix to be attached to the property name in the result.
Select to get the message ID.
Select to get the correlation ID.
Select to get any additional extended properties.
To run and execute the filter, click Run Filter. The results appear in the Filter Run Results section.
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|