Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA View.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro BRMSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type BRMSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your BRM.SAMPJCL members.

   Note: The following steps include instructions to execute the BRMSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the BRMEDALL member.

2. Open the SAMPJCL member BRM1ALL in an edit session and execute the BRMSEDIT macro from the command line.

   BRM1ALL is customized.

   Note: When upgrading into an existing CSI, comment out any allocation DD statements for existing files.

3. Submit BRM1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA View are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member BRM2CSI in an edit session and execute the BRMSEDIT macro from the command line.

   BRM2CSI is customized.

   Note: When upgrading into an existing CSI, comment out any allocation DD statements for existing files and delete the CREATCSI step. Change all ADD’s to REP’s.

5. Submit BRM2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.