System Administration: Defining Online Specifications › Define Logical Views › Use the View Selection List Input Commands › LOCATE Command

LOCATE Command

To locate a logical view in the View Selection List, do the following enter LOCATE view-id view-number on the command line and press Enter.

The view-number field is optional.

For example:

Command ===> LOC PAYRPT

If the specified logical View ID is not in the list, CA View scrolls to the entry that immediately precedes the specified identifier.

Note: If the ID contains quotes or spaces, it must be enclosed in single quotes. Any single quote in Report-id must be entered as a pair of single quotes because a non-paired single quote ends the ID. For example, if the value were JIM’S REPORT it must be entered as ‘JIM’’S REPORT’.