System Administration: Defining Online Specifications › Define Logical Views › Access the View Definition Panel › Change Logical Views

Change Logical Views

Do one of the following actions to change a logical view definition:

• Select a logical view definition from the View Selection List
• Retrieve a logical view definition with the SELECT command from the View Definition panel, changing the desired view information, and issuing the SAVE command.

Logical view definitions are not automatically saved. If a logical view definition is changed and not saved, a View Confirmation panel is displayed that allows you to SAVE or END without saving the logical view. If a temporary logical view was created, you can enter a specific view number to which the logical view is saved. The END key automatically identifies that the changes are to be ignored. A sample View Definition Confirmation panel follows:

 CA View ALL ------------------------ Confirm Change --------------------------
 Command ===>                                                                   
                                                                                
 View ID       ===> PAYRPT      
 View Number   ===> 1                            
                                                                                
 INSTRUCTIONS:                                                          
                                                                                
    Press ENTER key to save changes to view definition.
                     
    Enter END command to ignore changes to view definition.