Backup to tape and the creation of a new disk generation are normally performed automatically at a site-defined time and at site-defined intervals thereafter; however, tape backups can be initiated at any time with one of the following operator commands:
F SARSTC,DUMP F SARSTC,NEW F SARSTC,IDUMP F SARSTC,INEW
Where
Specifies that the new tape generation resides on the same tape as the previous generation, provided there is room on the tape and the maximum number of generations per tape (MAXGENT initialization parameter) is not exceeded
Specifies that the new tape generation resides on a new tape
Specifies that an interim backup cycle is initiated
This backup resides on the same tape as the previous backup, provided there is room on the tape, because the archival generation number is not incremented. (There is also an initialization parameter, MAXGENT, which specifies the maximum number of generations that are written to one tape.)
Specifies that an interim backup cycle is initiated
The archival generation number is not incremented; however, this backup resides on a new tape.
|
Copyright © 2013 CA.
All rights reserved.
|
|