Previous Topic: Upgrading from Previous ReleasesNext Topic: Configuration Steps to Upgrade to CA Deliver Release 12.1 without CA CSM

Migration Information › Upgrading from Previous Releases › Installation Steps for Upgrading to Release 12.1

Installation Steps for Upgrading to Release 12.1

To upgrade to Release 12.1, you must perform each installation step exactly as it is presented in the appropriate Installation chapter, unless the step has upgrade instructions in the table that follows.

The Step column lists the installation step in the chapter "Installation" and the Upgrade Instructions column explains what you must do to modify or replace the step.

Installation Step

Supplementary Upgrade Instructions

Step BRN1HOLD

No supplementary instructions.

Step BRN2ALL

Comment out or delete the allocations for any existing libraries. If you are upgrading from Release 11.7 or Version 12.0, and the panel libraries are sufficiently allocated, skip this step.

Step BRN3CSI
  • Comment out or delete the allocations for any existing libraries.
  • Comment out or delete the step that creates the CSI.
  • Change all ADD statements to REP statements.
  • If you are upgrading from Release 11.7 or Version 12.0, skip this step.

    Note: The default middle level qualifier name of the SMP/E CSI has been removed beginning with Release 11.6.

If you are upgrading from a previous release, be sure that the correct, complete name of your CSI is specified in the PARM= value on the execute card.

Step BRN4RECD, BRN5APP, BRN6ACC

No supplementary instructions.

Note: The default middle level qualifier name of the SMP/E CSI has been removed beginning with Release 11.6.

If you are upgrading from a previous release, be sure that the correct, complete name of your CSI is specified in the PARM= value on the execute card.