You can select one or more report identifiers for processing by entering one of the selection codes listed in the following table. Enter the selection code to the left of, and on the same line as, the report identifier to be selected.
An individual report identifier can be selected automatically by placing the cursor on the targeted entry and pressing the Enter key. The selection is equivalent to the S selection code. If a selection code or input command is entered, automatic selection does not occur.
Activates the report.
Deletes the report identifier and all its related references.
Displays the historical data for the report.
Displays the job data for the job that creates the report.
Displays the report definition attributes for the report.
Inactivates the report.
Forcibly inactivates the report.
Important! Use UF only as a last resort to clean up entries in a database because some entries can be left on the spool volumes.
|
Copyright © 2013 CA.
All rights reserved.
|
|