You can select one or more job names for processing by entering one of the selection codes listed in the following table. Enter the selection code to the left of, and on the same line as, the job name to be selected.
An individual job name can be selected automatically by placing the cursor on the targeted entry and pressing the Enter key. The selection is equivalent to the S selection code. If a selection code or input command is entered, automatic selection does not occur.
Activates all reports for the job name.
Deletes the job name and all its report definitions.
Presets the handling of the last rerun of previously-produced reports that belong to specified steps.
Renames the job name and its references within report definitions.
Enter the new name immediately to the right of the job name.
Displays the list of reports defined to the job name.
Inactivates all reports for the job name.
Forcibly inactivates all reports for the job name.
Important! Use UF only as a last resort to clean up entries in a database because some entries can be left on the spool volumes.
|
Copyright © 2013 CA.
All rights reserved.
|
|