You can select one or more report identifiers for processing by entering the selection code listed in the following table. Enter the selection code to the left of, and on the same line as, the report identifier to be selected.
An individual report identifier can be selected automatically by placing the cursor on the targeted entry and pressing the Enter key. The selection is equivalent to the S selection code. If a selection code or input command is entered, automatic selection does not occur.
The Distribution Lists for Distid panel also supports the full range of edit selection codes to copy, delete, insert, move, and repeat entries.
Note: For more information about selection code, see the section Tabular Commands in the chapter "Basics."
Displays the distribution data for the distribution identifier.
Displays the reports that the distribution list are defined to.
|
Copyright © 2013 CA.
All rights reserved.
|
|