Panels and Subpanels › Report Xref for Distid Panel › Input Commands

Input Commands

The following input commands are available on the Report Xref for Distid panels:

LEFT

Toggles the display between the four displays of the Report Xref for Distid panel

LOCATE

Scrolls to the entry whose name you specify as the operand of the command; if the specified name is not in the list, scrolls to the entry whose name immediately precedes that specified

For sorted lists, the LOCATE command traverses the list based on the first or only sort field.

Valid entries are L, LOC, and LOCATE.

RIGHT

Toggles the display between the four displays of the Report Xref for Distid panel

SELECT

Selects the report identifier you specify as the operand of the command for display

If the specified report identifier does not exist, an error message displays.

Valid entries are S, SEL, and SELECT.

SORT

Sorts the selection list display by report identifier or job name

The syntax of the SORT command is as follows:

SORT field

The following table identifies the field names that can be referenced on the SORT command and the predefined sort sequence used to order the data.

REPORT

Sorts by report identifier

Sort Sequence: Ascending

You can enter REPORT as RID or R.

JOBNAME

Sorts by job name

Sort Sequence: Ascending

You can enter JOBNAME as JOB or J.

To sort the selection list by job name, enter the command:

sort job                                           

After the list is sorted, you can use the LOCATE command to traverse the list based on the first or only sort field. For example, if the list is sorted by job name, LOCATE PROD scrolls the list to the entry or closest entry whose job name is PROD.