Defining Basic Reports › Defining Basic Reports › Step 2: Define a Job

Step 2: Define a Job

The second step in defining a basic report is to specify a name for the job that creates the reports. Use TRJOB01, the name you specified in your first JCL for the job.

1. On the command line of the Primary Selection Menu panel, enter J, a space, and then the job name TRJOB01.

    CA Deliver - Primary Selection for DELIVER.SYSTEM1 ---------------------------
    Command ===> J TRJOB01
    
      A Active Display    - Display selection list of active reports or bundles.
      B Bundle Data       - Display bundle data.
      D Distribution Data - Display distribution data.
      J Job Data          - Display job data.
      R Report Data       - Display report data.
    
        Operands for A:
          B    - Display selection list of active bundles.
          R    - Display selection list of active reports (default).
          X    - Limit selection list to exceptions.
          PREV - Display selection list for previous cycle.
    
        Operand for B,D,J,R:
          Omit operand for complete selection list.
          Specify identifier to display data.
          Specify generic identifier for limited selection list.
          L    - For D only, display list of distribution lists.
   
      Enter END command to terminate this CA Deliver session.
   
   

2. Press Enter to display the Reports for Job panel.

    CA Deliver ---------------- Reports for Job: TRJOB01 ------- Row 00001 of 00010
    Command ===>                                                  Scroll ===> PAGE
   
    Desc    ===>
    Prevrun ===>
   
   Sel Stepname Procstep DDname   Report ID                        Type    Prevrun
   
   
   
   
   
   
   
   ***************************** BOTTOM OF DATA ********************************
   

   Note: Both PREVRUN fields shown on the Reports for Job panel work only when CA 11 is installed and set up for use with CA Deliver at your site.