Processing, DBUTLTY and SQL Messages › CA Datacom/DB Processing Messages (DB0xxxxc) › DB00141I

DB00141I

DBUTLTY start/end function(-modifier) base optional-area Job-name

Reason:

This message notes the start and end of key DBUTLTY functions that run with some degree of isolation required. It only occurs with using the SIMPLIFY mode. The details of the message and specific functions are shown following:

• BACKUP-x-y
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
    • U - if MULTUSE=YES was not specified
  • y is replaced by the following letters
    • N - if the backup had SEQ=NATIVE
    • U - if the backup had SEQ=PHYSICAL,UPDATE=YES
    • P - if the backup had SEQ=PHYSICAL without UPDATE=YES

  The BACKUP message is done for a data area backup only.

• EXTEND is used when extending with AREA=IXX.
• EXTEND-x is used when extending a data area.
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
    • U - if MULTUSE=YES was not specified
• EXTRACT-x-y is used where the description of the x and y are the same as for BACKUP.
• INIT is used when initializing with AREA=IXX.
• INIT-x is used when initializing a data area.
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
    • U - if MULTUSE=YES was not specified
• LOAD-x is used when initializing a data area.
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
    • U - if MULTUSE=YES was not specified
• RECOVERY-x is used when recovering data.
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
    • U - if MULTUSE=YES was not specified
• REORG-x is used only during the data load section when loading a data area.
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
    • U - if MULTUSE=YES was not specified
• RETIX-x is used when initializing a data area.
  • x is replaced by the following letters:
    • M - if the function specified MULTUSE=YES
• U - if MULTUSE=YES was not specified  

  Note: The area name is provided for functions where it was specified or blanks if it was not specified, such as a full base LOAD.

Action:

None. This message is for information only.