Reason:
In the message text above:
is a physical log block number in hexadecimal of where CA Datacom must start scanning if restart is necessary.
is a physical log block number in hexadecimal of where CA Datacom must start reprocessing requests if restart is necessary.
is either low values or a date/time indicating when the restart process must start reprocessing, should it become necessary.
This message is part of a set of three messages: DB01212I, DB01213I, and DB01214I. They are diagnostic in nature, and the default is that they do not print. They can be set to print using the MUF startup option X_RESTART_MSGS set to YES. The data printed is intended for CA Support in case of any problem that could involve the restart process.
A date/time of low values indicates all records starting at the REDO block. Otherwise, the date and time might be within the REDO block or to the right of it.
If the log is found open and to show the information that restart is using to perform the restart, this message and the set, if turned on, occur on the console before the restart process begins. Whether or not the log is found open, the message and set occur after the restart process is complete to show the log status at the point of enable. If the Multi-User Facility fails to end normally and has control of the abnormal termination, the messages occur as part of the EOJ report in the logging status section.
Action:
None. This message is for information only.
|
Copyright © 2014 CA.
All rights reserved.
|
|