How to Use

AUTOCOLL (Collect and Manage Snapshots) › Create a Snapshot › How to Use

How to Use

Use the following syntax to write this command:

►►─ AUTOCOLL ─ OPTION=SNAPSHOT,MUFNAME=mufname ───────────────────────────────►

 ►─┬───────────────────────┬─┬─────────────────────┬──────────────────────────►◄
   └─ ,DBID= ─┬─ 1019 ◄ ─┬─┘ └─ ,OUTNAME=cccccccc ─┘
              └─ nnnn ───┘

Command

AUTOCOLL: Invokes the AUTOCOLL function.

Required Keywords

OPTION=SNAPSHOT

Specifies to create a Snapshot rowset.

MUFNAME=

Specifies the name of the source MUF.

Valid Entries:: Valid MUF name (1 to 8 characters)
Default Value:: (No default)

Optional Keywords

DBID=

Specifies the database ID of the Snapshot database where the Snapshot will be recorded.

Valid Entries:: 1 to 5000
Default Value:: 1019

OUTNAME=

Specifies an alternate character value to use as the MUFNAME stored on the rows written to the Snapshot database. This allows you to organize the collected data under selected MUFNAMEs as needed. The OUTNAME option is typically used in special cases only.

Valid Entries:: 1 to 8 characters
Default Value:: (No default)