Only use this parameter when you want to establish a system-level authorization identifier, or when you want to disable (by specifying DEFAULT) dynamic plan selection. For more information about dynamic plan selection, see the information about the PLANSWI= parameter in PLANSWI= and in Controlling Dynamic Plan Selection.
Specifying AUTHID=DEFAULT indicates that there is no system-level AUTHID defined. It also indicates not to reference the Dynamic Plan Selection Table (DCTABPR). If you specify DEFAULT, the incoming AUTHID is left intact in all cases.
If you specify AUTHID=authid, CA Datacom CICS Services does not perform dynamic plan selection but uses this authid value for all requests. Therefore, the specified authid value becomes the system-level AUTHID.
DEFAULT, or a 1- to 18-character authorization identifier to be used as the system-level AUTHID.
Note: The AUTHID= and PLANSWI= parameters are mutually exclusive.
DEFAULT
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|