|
|
|
The topics in this section describe the manual tasks you perform if you are not configuring your product using CA MSM.
Sites should run the steps to build, populate, and mass-edit the installation JCL data set. This is accomplished by running member AXCUS00 in CAAXSAMP to create the INSTJCL PDS. Before executing AXCUS00, fill out the Installation Worksheet according to your site standards (see Installation Worksheet). When you have accomplished that task, apply those values to a special member, $DCAXEDT. To modify this member, use special instructions in the member or execute $DCAXEDT member ISREDIT. Never save this member in CAAXSAMP because it is under SMP/E control.
You can copy $DCAXEDT to your personal CLIST library and make the changes necessary following the work sheet you have filled out.
This installation process assumes that you are using an ISPF terminal that displays the “ ^ “ (the caret symbol). This character exists as the shift key character above the number 6 key on your keyboard. The ISPF terminal type is set in ISPF option 0, and 3278 is a terminal type that displays the caret symbol correctly. Your 3270 terminal or terminal emulation code page setting can also influence the display of characters.
All sites should run the step to utilize CAIRIM to load the CA Datacom Version 14.0 PC Calls into the z/OS operating system. Sites should also follow the procedure to permanently add this PC Call activation to the sites CAS9 procedure. The installation process that follows gives details about using member AXRIM01 to install the PC Calls.
All sites should run the AXCUS01 and AXNEW01 steps to build a new CA Datacom/AD environment. Upon completion, you have a fully functional CA Datacom/AD environment ready to be used to support the other CA Technologies products installed.
| Copyright © 2012 CA. All rights reserved. | Tell Technical Publications how we can improve this information |