iConsole User Guide › iConsole Administration › Integration with BusinessObjects Enterprise › BusinessObjects Integration Settings

BusinessObjects Integration Settings

Specify the following integration settings:

The name or IP address of the server hosting BusinessObjects.

Specify the FQDN (fully qualified domain name) or IP address of the server hosting BusinessObjects Enterprise.

The TCP port used by the iConsole to log on to BusinessObjects Enterprise.

In BusinessObjects terminology, this is the CMS Name Server Port. It defaults to port 6400. Normally, you do not need to change this port number. But if your BusinessObjects Enterprise installation uses a different port number, specify that number here.

The TCP port to be used by the iConsole to connect to the BusinessObjects web service.

The iConsole calls this web service to display the available BusinessObjects reports, retrieve report results, and access the InfoView web portal.

The default is port 8080. Normally, you do not need to change this port number. But if the BusinessObjects Enterprise web service uses a different port number, specify that number here.

The InfoView folder containing CA DataMinder reports.

Specifies the folder where common BusinessObjects reports for CA DataMinder are found.

BusinessObjects reports for CA DataMinder are available in InfoView on the Document List page. Specify the folder on the Document List page that contains the common reports. (Users can save their own customized reports in a separate 'Personal Reports' folder.)

Enable integration with BusinessObjects Enterprise?

Select this check box to enable users to run BusinessObjects reports for CA DataMinder.

Note: Any changes to these settings apply to all your iConsole front-end web servers.