Previous Topic: Verify that the Cavium Driver is up to DateNext Topic: Assign IP Addresses

Network Integration Guide › Bivio Platform Software Installation › Verify the NBA Installation

Verify the NBA Installation

At the end of the NBA package installation, the installer runs the "installcheck" script automatically. This script verifies that the basic installation steps have completed successfully. The script does not perform an extensive test of the entire system.

You can run the script manually at any time.

To check the installation

  1. Execute the following command from an NBA CPU-X root login: 
    ta] CPU-X:~ # installcheck

    On Bivio 7000 appliances, this generates output similar to this:

    =====================================================================
=           NBA Installation Checker    Version 14.5.3200.0 
=====================================================================

OS = 5.0.7-3 (Build 201008021214)                                  OK
NBA version = 14.5.3200.0                                          OK
NBA product branding                                               OK
Ethernet port failover                                             OK
NBA services                                                       OK
---------------------------------------------------------------------
Overall result of all installation checks (All passed)             OK
---------------------------------------------------------------------
  2. Manually check that the reported ‘NBA version’ is the required one.
  3. If you see any Error results in the above check, wait briefly, then run the check again.

    Such errors are caused by a delay in some components starting after a reboot. If the error is still reported after five minutes, there is a problem with the installation.