To perform this installation, you will need a PC with suitable software installed. Actual details about PC configuration and the application user interface will vary according to the operating system and applications used. This chapter therefore only provides a general outline of the commands to use on the PC.
The installation is in two stages. First, you must check the equipment for the correct hardware configuration. Then you can install the NBA software package.
Note: The management port must be on a different network to the internal NBA expresslane network (which by default is 10.10.10.0). The NBA will prevent you from trying to configure both interfaces on the same network, but if existing network traffic uses 10.10.10.0 you need to reconfigure the expresslane network. For instructions, see Troubleshooting in this manual or contact CA Technical Support at http://ca.com/support.
|
Copyright © 2014 CA.
All rights reserved.
|
|