Previous Topic: (Optional) Configure External Bypass UnitNext Topic: Upgrade the NBA


Verify the NBA Installation

At the end of the NBA package installation, the installer runs the "installcheck" script automatically. This script verifies that the basic installation steps have completed successfully. The script does not perform an extensive test of the entire system.

You can run the script manually at any time with the following command at the shell prompt:

installcheck

To verify the NBA installation:

  1. Run the installcheck script.
  2. Verify that the reported NBA version is the required one.
  3. If you see any error results in the check output during the first run, wait briefly, then run the check again. Often, errors are caused by a delay in some components starting after a reboot.
  4. If an error is still reported after five minutes, there is a problem with the installation.

On the Linux Server Platform, the script generates output similar to the following:

===============================================================================
=                                                                             =
=         CA DataMinder Network Installation Checker    Version 14.0.2800.0          =
=                                                                             =
===============================================================================

OS = CentOS Linux release 6.0 (2.6.32-71.el6.x86_64)                         OK
NBA version = 14.0.2800.0                                                    OK
Napatech card = NT4E-4T-INL In-line Network Adapter PCIe 4x1Gb RJ45          OK
Napatech driver version = 1.3.0.14565                                        OK
NBA services                                                                 OK
-------------------------------------------------------------------------------
Overall result of all installation checks (All passed)                       OK
-------------------------------------------------------------------------------