Network Integration Guide › Technical Information › SNMP Support › NBA Traps › Specify a Trap Destination

Specify a Trap Destination

When you set up SNMP support on the NBA, you need to specify where the traps are sent to. Specifically, you need to supply the IP address of the machine hosting your SNMP manager.

To specify a trap destination

1. In the SNMP screen, go to the Traps section.
2. In the Sink Addresses field, specify the IP address of the target machine and then click Add. The new address is displayed in the console immediately above the Sink Addresses field.

   Note: You must specify an IP address; you cannot specify a machine name.

3. If required, you can add further machines. Use the Add and Remove buttons to modify the list of sink addresses.