Archive Integration Guide › Import Policy › Hub Mode › Configure the Event Import Job

Configure the Event Import Job

The final step in connecting a policy engine to Event Import is to configure the import parameters and start the import job.

When connecting a policy engine to Event Import, you need to configure Event Import parameters in the import configuration file, import.ini. These parameters must cover the usual areas (specifying the source data for the import job, and so on).

Required Import Parameter

In particular, Import Policy jobs must include the following parameter:

Engine.UsePolicyEngineConnector=Yes

This parameter specifies whether imported events are sent directly to a local policy engine or to a remote policy engine via the policy engine connector. Set this parameter to:

Yes to configure Import Policy to use direct mode.

Hub to configure Import Policy to run in hub mode.

Parameters not Supported for Import Policy

You cannot use these parameters with Import Policy:

EMail.InternalAddrPattern
Engine.BulkImportUsername
Engine.BulkImportUserpasswd
Engine.EventRetentionPeriod
EMail.StoreMessageClass

More information:

Engine Parameters

Event Import Parameters