Integrate CA NetMaster NM for TCP/IP with CA Introscope › How You Integrate CA NetMaster NM for TCP/IP with CA Introscope › Configure CA NetMaster NM for TCP/IP

Configure CA NetMaster NM for TCP/IP

You configure CA NetMaster NM for TCP/IP to enable the region to feed performance data to CA Introscope.

Follow these steps:

1. Verify that the TESTEXEC(RUNSYSIN) member for the region contains the following parameter:

   PPREF='PROD=APM'
   

   Important! If you update the member, restart both the region and the associated SOLVE Subsystem Interface (SSI).

2. Log on to the region.
3. Enter /PARMS at the Command prompt.

   A list of parameter groups appears.

4. Enter F APMEPAGENT.

   The command finds the parameter group that enables the data feed.

5. Enter B next to the parameter group.
6. Verify that the following fields have the indicated values:

    .- APMEPAGENT - CA Introscope EPAgent ----------------------------------------.
    | CA Introscope Environment Performance Agent:                                |
    |   Enable EPAgent Client? ................... YES  (Yes or No)               |
    |   IP Addr/Host Name ... epa_ip_address                                      |
    |   EPAgent Network Data Port ................ 8000                           |
   

   epa_ip_address

   Identifies the IP address or host name of EPAgent.

   Note: If an update is required, press the F4 (Update) function key. After your changes, press F6 (Action) to apply the changes effective immediately in the region, then press F3 (File) to save the changes.

The region is already feeding or starts to feed data to CA Introscope.