Reference Guide › Configuration Files › The seos.ini Initialization File › seagent

seagent

In the [seagent] section, the tokens control the behavior of the seagent daemon.

debug_backup_dir

Specifies the location of the backup debug files.

Default: CA ControlMinder product log directory

debug_backup_num

Defines the number of backup debug files to save.

Values: A positive number

Default: 2

debug_file

Defines the name of the file to which CA ControlMinder writes seagent debug messages.

Default: ACInstallDir/log/seagent_debug

debug_level

Specifies the minimal level of debug messages that CA Access Control writes to the debug file.

Limits:

• disabled—no messages are written to the debug file
• critical—CRITICAL messages are written to the debug file
• very_high—CRITICAL and VERY_HIGH messages are written to the debug file
• high—CRITICAL, VERY_HIGH, and HIGH messages are written to the debug file
• normal—CRITICAL, VERY_HIGH, HIGH, and NORMAL messages are written to the debug file
• low—CRITICAL, VERY_HIGH, HIGH, NORMAL, and LOW messages are written to the debug file

Default: critical

watchdog_check_interval

Defines the time interval, in seconds, at which seagent checks that seoswd exists.

Note: This token applies only if there is a high volume of incoming connections to seagent. If seagent is idle, it checks that seoswd exists every 3 seconds and this token is ignored.

Default: 30